Norwood Kwik-Till HSD2500, Руководство оператора

Страница: 81 / 154

4 - WORKING OPERATIONS
4-15
Kwik-Till Folding
1. If the Kwik-Till is already attached to the tractor, proceed
to step # 2, if not already attached to the tractor. (See
“Attaching and Detaching Kwik-Till To/From Tractor” on
page 3-8)
2. Transport the Kwik-Till onto level ground.
(See Fig. # 4-25)
WARNING
Before disconnecting equipment, servicing, adjusting,
or repairing :
Park on a level surface, engage park brake, place
transmission in PARK, shut off engine, remove key, and wait
for all moving parts to stop before leaving the tractor cab.
3. If the Kwik-Till is in the “Field Raised Position”
(See Fig.
# 4-37)
, proceed to step # 5, if not proceed to the next
step.
Fig. # 4-37 “Field Raised Position”
4. Start the tractor and set to high idle, position the Kwik-
Till into the “Field Raised Position” make sure that the
Rear Roller
A
and Front Wheel Cylinders
B
are fully
extended. When these cylinders are extended, the disks
will be completely off the ground.
(See Fig. # 4-38)
A B
Fig. # 4-38 “Field Raised Position”
IMPORTANT
If transport width is an issue, retract the rear roller cylinders
and place 9 depth stops down. This will make the transport
width narrower, but will increase the transport height.
5. Remove the Main Frame Lift & Wing Fold cylinders from
FLOAT POSITION .
(See Fig. # 4-39)
Fig. # 4-39 Tractor Remote Valve Levers Removing SCV
From Float Position
6. Use the tractor remote valve lever to retract the Main
Frame Lift
A
cylinders to raise Center Section
B
,
Left Wing
C
, & Right Wing
D
from the ground.
(See
Fig. # 4-40)
A
A
C
B
D
Fig. # 4-40 Fold Step # 1 - Raising Rear Sections (Field
Raised Position Shown)