Norton clipper CMR 351, Руководство по эксплуатации

Страница: 10 / 20

10
2.4 Technical Data
Electric motor protection IP54
Power 2,2kW
Tension 230V 1~
Max. blade diameter 350 mm
Bore 25,4 mm
Rotation speed of the blade 2800 min
-1
Cutting depth 100 mm (without reversing the material)
Cutting length 1150 mm
Length 1650 mm
Width (with side extension) 1030 mm
Width (without extension) 700 mm
Height (with feet) 1550 mm
Height (without feet) 875 mm
Flange diameter 90 mm
Water pan capacity 65 l
Sound pressure level 80 dB (A) (following ISO EN 11201)
Sound energy level 92 dB (A) (following ISO EN 3744)
Weight (total) 125 kg
Weight (with water) 190 kg
3 Assembly and commissioning
The machine is delivered fully equipped (although without diamond blade) and is ready for operation
after assembly of the blade and feet, and connection to the appropriate power supply.
3.1 Feet and side extension assembly
To assemble each foot, slide it at a corner of the machine so that the long holes on the foot are
located under the head of the knob screws. Then secure the foot by tightening the knob screws.
Repeat this operation for every foot on the four corners of the frame.
The side extension can be assembled either left of right on the frame of the machine. Slide the two
strips on the end of the extension inside the two notches on the frame. Then secure the extension
using the two knob screws.
3.2 Tool assembly
Only NORTON blades with a maximum diameter of 350 mm can be used with the CMR 351.
All tools used must be selected with regard to their maximum permitted cutting speed for the
machine’s maximum permitted rotation speed.
Before mounting a new blade into the machine, switch off the machine and isolate it from the main
source of electricity.
To mount a new blade, follow these steps:
•
Open the outside cover of blade guard by loosening the screw on the front side of the guard.
•
Loosen the hexagonal nut (Caution: left-threaded) on the blade shaft, which holds the
removable outer flange.