Norton clipper CMR 351, Руководство по эксплуатации

Страница: 13 / 20

13
•
Lower the cutting head to the desired cutting depth (in “through cutting”, lower cutting head until
blade periphery reaches max. 3mm under the surface of the conveyor cart) by means of the
handle over the cutting head
•
Fix position by tightening the clamping device over the blade guard
•
Put material on the table
•
Push the cutting head slowly and without undue pressure towards the material and cut the
material as shown on the picture.
•
You can also cut thicker material by reversing the material on the table.
NOTE: While recommended, it is not absolutely necessary to lock the cutting head into a given
depth position when jam cutting. The desired cutting depth can be maintained by holding firmly the
depth feed handle on the blade guard. If the full depth of cut requires excessive pressure (on very
dense material e.g.) make 2 or 3 shallow cuts.
5.3 General advice for the cutting
•
Material weighting under 30 kg and having dimensions smaller than 1150x1000x200mm can be
cut with the machine.
•
Before commencing work make sure tools are firmly seated!
•
Select the right tools as recommended by the manufacturer depending on the material to be
worked, the working procedure (dry or wet cut) to be carried out and the required efficiency.
•
Apply cooling water continuously whilst cutting and in good time! Make sure the water pan
contains enough water.
•
When dry cutting, ensure sufficient dust extraction and wear a dusk protection mask!
•
If the thermal protection trips, allow the thermal protection to cool down. Wait a few minutes to
allow the motor to cool down before restarting the machine.