Norton clipper CHW Series, Руководство по эксплуатации

Страница: 12 / 23

12
3.3 Electrical connections
Electrical connections
Check that,
•
the voltage/phase supply corresponds to the information indicated on the motor plate.
•
Available power supply must have ground connection in conformity with safety regulations.
•
The connecting cables should have at least a 2.5mm
2
-section per phase.
3.4 Water cooling system
Fill the water pan with clean water to approximately 2cm from top (ensure that bottom of pump is
fully immersed in water). Use the pump switch so you can use the pump.
Open water-tap at blade guard (note that handle on water-tap should be in line with water-flow).
Ensure that water is flowing freely in the circuit and is delivered adequately to both sides of the
blade, as insufficient water supply may result in premature failure of the diamond blade.
The water pump must never run without water. Always make sure that there is enough water in the
pan and refill if necessary.
In case of frost, empty the water cooling system from its water.
4 Transport and storing
4.1 Securing for transport
Before transporting or lifting the machine, always remove the blade and empty the water pan. You
can transport the machine mounted, or you can remove some parts from the machine so it is lighter.
Picture 2 : Securing the conveyor cart Picture 3 : Securing the water pan
a) If you want to transport the machine mounted, you have to secure the conveyor cart and the
water pan:
•
To secure the cart (picture 2), loosen the wing nut (1) and turn the blocking device until it takes
the screw (3). Then retighten the wing nut.
•
To secure the water pan (picture 3), make sure the blocking device (1) is in the shown position.
b) You can also remove the conveyor cart and the water pan:
•
To remove the cart, loosen the wing nut (1 on picture 2) and turn the blocking device until it is
parallel to the scale. Loosen the knobs on each side of the conveyor cart (1 on picture 4), and
put the anti-tipping device in its lower position. Then remove the cart.
•
Before removing the pan, take the water pump out of it. Open the blocking device (1 on picture
3) and pull the pan out of the profiles.