Norton clipper CHW Series, Руководство по эксплуатации

Страница: 11 / 23

11
3 Assembly and commissioning
The machine is delivered fully equipped and assembled (although without diamond blade) and is
ready for operation after connection to the appropriate power supply.
3.1 Head locking
To make sure the machine is not damaged during transport, the locking handle of the head is
removed. Remove the screw in the locking axle, and replace it by the locking handle (1) supplied as
indicated on picture 1.
Picture 1 : assembling the locking handle
3.2 Tool assembly
Only NORTON blades with a maximum diameter of 350 mm can be used with the CHW.
All tools used must be selected with regard to their maximum permitted cutting speed for the
machine’s maximum permitted rotation speed.
Before mounting a new blade into the machine, switch off the machine and isolate it from the main
source of electricity.
To mount a new blade, follow these steps:
•
Open the outside cover of blade guard by loosening the two knobs on the side of the guard.
•
Loosen the hexagonal nut on the blade shaft, which holds the removable outer flange.
•
Remove the outer flange.
•
Clean the flanges and blade shaft and inspect for wear.
•
Mount the blade on arbor ensuring that direction of rotation is correct. Wrong direction of rotation
blunts the blade quickly.
•
Replace outer blade flange.
•
Tighten hexagonal nut with spanner supplied for this purpose.
•
Shut retractable blade guard cover and tighten the two knobs.
The blade bore must correspond exactly to the diameter of the blade shaft. Cracked or damaged
bore is dangerous for the operator and for the machine.