Norton clipper CHW Series, Руководство по эксплуатации

Страница: 17 / 23

17
7 Faults: causes and cures
7.1 Fault-finding procedures
Should any fault occur during the use of the machine, turn it off, and isolate it from the electrical
supply. Any works dealing with the electrical system or supply of the machine can only be carried
out by a qualified electrician.
7.2 Trouble-shooting guide
Trouble Possible source Resolution
No electricity Check the electrical supply
(fuse for example)
Connection cable section too
small Change connection cable
Defective connection cable Change connection cable
Defective switch CAUTION : can only be solved
by qualified electrician
Motor is not running
Defective motor Change motor or contact motor
manufacturer
Cutting advance too quick Cut slowly
Blade is blunt or glazed Sharpen the blade in
calcareous stone
Defective blade Change blade
Motor stops during the cutting,
but can be restarted after a
short period (overload
protection)
Wrong blade specification for
the application Change blade
Not enough water in the pan Refill the water pan
Water pump is switched off Switch the water pump on
Water tap is closed Open tap on blade cover
Water supply system is blocked
up Clean water supply system
No water on the blade
Water pump is not working Prime the pump
Reactivate switch
CAUTION : if switch trips again,
problem can only be solved by
a qualified electrician