NorthStar 961X, Руководство по установке

Страница: 42 / 86

SECTION TWO - Installation
Page 32 961 INSTALLATION MANUAL Revision A
1. Press and hold the
PWR
key for three seconds, and the 961 will turn
off.
To turn off an entire system (the two heads and the processor) with two
control heads that are on:
1. Press and hold the
PWR
key for approximately two seconds until the
POWER-OFF
dialog appears, as shown.
2. To turn off only one head (where you pressed the
PWR
key, press the
THIS HEAD
key. Otherwise, to turn off the entire system, press the
BOTH HEADS
key.
Testing and troubleshooting the 961
To test the system after installation, first apply power to the control head:
Pressing the control head’s
PWR
key automatically turns the entire sys-
tem on, including the processor. Next, check for the presence of GPS and
DGPS signals: For GPS signals, the time-to-first-fix (TTFF) is about two to
five minutes; for DPGS signals, it may take at least 20 minutes for the first
channel of the 961’s internal beacon receiver to lock onto a transmit-
ter–keep checking for the presence of the word
DGPS
in the upper-left
corner of the
CHART
screen.
Troubleshooting
common
installation
problems
Typical problems you may encounter during or after the installation pro-
cess are outlined in Tables 2, 3, and 4. If you’ve followed the troubleshoot-
ing steps below and are still experiencing difficulties, call the Northstar
Service Department at 978-897-6600 and ask to speak with a marine ser-
vice technician.
Table 2: Troubleshooting the installation
Problem Area Symptom Possible Solutions/Reasons
POWER Pressing the
PWR
button doesn’t power-up
the unit.
•
Check the fuse and the power to the
head.