NorthStar 961X, Руководство по установке

Страница: 66 / 86

SECTION THREE - Interfacing
Page 56 961 INSTALLATION MANUAL Revision A
The following configuration parameters are available as outlined in Table
9 below.
Table 9: PPNM output setup parameters
The 961’s PPNM default settings are 200 ppnm, 100 milliseconds, and
200 milliseconds.
To change the PPNM settings:
1. Press the
CURSOR PAD
down to highlight
PULSES PER NAUTICAL
MILE
,
PULSE TIME MINIMUM
, or
PULSE SEPARATION MINIMUM
, then
press the
EDIT
key.
2. Enter the desired parameters, then press the
ACCEPT
key (or press
CANCEL
to leave the option unchanged).
Using VGA output
The 961XD supports an external VGA monitor output from the female
15-pin standard VGA video connector located on the back of the proces-
sor (See Figure 14 on page 21). Conversion of the signal to an NTSC or
PAL video output is possible using VGA converters. Use a VGA-to-NTSC/
PAL converter that doesn’t require separate software. This should be
plug-and-play hardware for standard VGA video input conversion, sup-
porting frame buffering at 75-Hz refresh rate. Also, consider the require-
ments for power: A unit requiring a DC power source is less likely to
cause interference.
Parameter Options
Pulses per nautical mile Enter
1
to
999
pulses
Pulse time minimum Enter
1
to
999
milliseconds
Pulse separation time Enter
1
to
999
milliseconds