NorthStar 6000i, Руководство по установке

Страница: 45 / 56

SECTION SIX: Interfacing the 6000i system
6000i
Installation Manual, Rev. G Page 41
4. Terminate and solder the appropriate wires to the appropriate pins:
•
For wiring a 6000i to a 958 or 957, see Figure 18 and Table 12 on page 42.
•
For wiring a 6000i to a 952, 951 or 941, see Figure 19 and Table 13 on page 43.
5. Slide the twist lock onto the connector body.
6. Screw the connector backshell to the connector body, and tighten.
7. Install the strain-relief clamp with two screws.
8. Connect one end of the cable to the Aux Port at the back of the
6000i , and the other
end into the Aux Port at the back of the older unit.
9. Turn both units on, and configure both units’ AUX ports to the D/B TRANSFER
function as described above. Turn both units off and on again to initialize the ports.
10. Test for the proper cable connection: a) Press
WAYPTS/ROUTES
; b) Press
IMPORT/
EXPORT
; c) Press
IMPORT DATA
or
EXPORT DATA
; d) Press
TEST COMM
. The
message should read
REMOTE LINK OK
. If so, the hardware connection is successful and
the two units can now transfer all waypoints and routes between them.
6000i 6-PIN AUX CONNECTOR 957/958 6-PIN AUX
No connect
Aux input A
Ground/shield
Aux output A
Aux input B
Aux output B
Shield termination
Aux output A
Aux input A
Aux output B
Aux input B
Ground/shield
Pin number
No connect
Pin number
seen from solder cup side
Figure 18: Connection to a 957 or 958