NorthStar 6000i, Руководство по установке

Страница: 31 / 56

6000i Installation Manual, Rev. G Page 27
SECTION FIVE: Checking out the
system
Turning the
6000i
on and off
To turn on the 6000i , gently and briefly press the
PWR
key. The unit emits several short beeps as it
displays the
START-UP
screen, then performs a series of self-tests to check its critical components and
functions. Next, a message is shown reminding against relying on the 6000i’s chart cartography as
the only means of safe navigation. To turn the unit off, press and hold the
PWR
key for several
seconds, until it turns off.
Inserting chart cartridges
The 6000i uses either Navionics Classic
cartridges or XL3 cartridges. Older style
Navionics cartridges (used with Northstar
900 series navigators) cannot be used
with the 6000i. Cartridges can be inserted
or removed at any time, even if the unit is
turned on. The cartridge slot is located
behind the
6000i’s keypad, which opens
as shown in Figure 13. The latch is at the
left edge of the door. Push it to the right
to open the door.
The cartridge only fits one way. If it
doesn’t slide in smoothly, try the other
way. Insert the cartridge gently but firmly
with one straight, smooth motion. A cartridge can be safely inserted or removed while the
6000i is
turned on.
Be sure to close the door securely to avoid water penetration!
Checking satellite status
To see information about signals from the satellites, press
POSITION
and then
Sat Info
.
The satellite map on the
GPS SATELLITES
screen shows the current location of the satellites in the
sky. The 6000i displays GPS satellites as circles; WAAS satellites as ovals. You can check the quality
SPLIT
WAY
PYS
ROUTES
SAVE
MOB
IN
OUT
Figure 13: Inserting a cartridge