NorthStar 6000i, Руководство по установке

Страница: 36 / 56

SECTION SIX: Interfacing the 6000i system
Page 32 6000i Installation Manual, Rev. G
The NMEA connector
The 6000i’s NMEA connector contains the following functions: NMEA Port 1, NMEA Port 2, RS-232
Port, and the “Honk,” “200 ppnm” or “remote power control” signal.
Wiring the NMEA connector pins
Configuring the NMEA output ports
You can set each output port to meet the requirements of devices that conform to the NMEA 0183 or
other data-format specifications: Press
STAR
to display the
OPTIONS/SERVICE INFO
screen, then press
PORT SETUP OPTIONS
to display the
PORT SETUP OPTIONS
screen. Press
PORT 1 SETUP
or
PORT 2
SETUP
to display a list of data-format control options, as shown below.
Table 9: NMEA connector pins
Description Wire color Pin
NMEA port 1 input A brown 3
NMEA port 1 input B blue 1
NMEA port 1 input ground white with blue stripe 4
NMEA port 1 output A violet 12
NMEA port 1 output B gray 7
NMEA port 1 output ground blue with white stripe 8
NMEA port 2 input A white with brown stripe 6
NMEA port 2 input B brown with white stripe 2
NMEA port 2 input ground white 5
NMEA port 2 output A yellow 15
NMEA port 2 output B orange 11
NMEA port 2 output ground black 10
RS-232 ground tan 17
RS-232 RX green 16
RS-232 TX red 18
External ground/foil drain white with orange shield 9
Reserved orange with white stripe 13
Honk out/200 PPNM (pulses per
nautical mile)/remote power pink 14
Figure 15: NMEA
connector pin
configuration