Northern Lights OWN-ADV, Инструкция по установке и эксплуатации

Страница: 62 / 91

OWN-ADV 01/12
9.3 REGISTER MAP (CONT’D)
60
40175 PCB Board
Temperature -55 ~ 130
Signed Integer
16 bit R 1 bit 0.1C
Reading 1000 corresponds to 100.0C
Positive or negative values can be
identi
fi ed by reading the high byte of
MSB. A 1 in bit 15 corresponds to a
negative number while a 0 corresponds
to a positive number
C
40176 Current Run time
(Total run time on
active running event).
NOTE: Timer is reset
to Zero after active
running event has
been terminated (OFF
or AUTO mode
waiting to start) 0 ~ 6553.5 R 1 bit 0.1 hour
65535 corresponds to 6553.5Hs
Hours
40177 ~
40178 Engine Hours (old
way – use
registers
40172/40173
instead) 0~255999.9 R Total Accumulated running hours, the
reading in 40177, 1 bit equal to 0.1
hour. The reading in 40178, 1 bit equal
to 1000 hours. So the total hours =
40178 * 1000 + 40177/10
Hours
40145 Maintenance Time -1000 ~ +1000
Signed Integer
16 bit R The unit is 0.1 hour (1 bit = 0.1 hour);
Positive values count down the hours to next
maintenance. Negative values count up the
hours since maintenance should have been
performed. Positive or negative values can be
identi
fi ed by read the high byte of MSB. A 1 in
bit 15 corresponds to a negative number while
a 0 corresponds to a positive number.
2. Events History Log
40130 Read Previous Entry 0x6C93
(27795) W Write control command to holding
register address
Read Next Entry 0x639C
(25500) W
The controller will check the log request every 1 second. Each time a new command is received, the
controller will scroll either down or up one message (until it reaches either the bottom or top of the
message log), and update the log content in address 40131 to 40141. Once at the top of the log,
registers 40131 to 40141 are not changed if a “Read Previous Entry” command is received. Once at
the bottom log, registers 40131 to 40141 are not changed is a “Read Next Entry” command is received.
After 20s of receiving further commands in register 40130, all registers are cleared (i.e. set to 0).