Northern Lights OWN-ADV, Инструкция по установке и эксплуатации

Страница: 44 / 91

OWN-ADV 01/12
42
There are 3 main display pages for remote unit: the REMOTE UNIT SETTINGS page, ON-LINE GENSET
STATUS page and ON-LINE GENSET PARAMETERS page. When the WaveNet Remote unit powers on,
it will go to the ON-LINE GENSET STATUS page.
Up to three gensets can communicate on the NMEA 2000 network and those which are active are dis-
played on the three main lines of the Online Genset Status screen. Each line displays the on-line
Genset
Controller’s Name
,
State
and the
Status Mark
. Above, relevant messages of the selected genset, like
warnings and running detail, are shown.
Move the cursor between the genset controller names using the Up and Down keys and press the Enter
key to switch to the ON-LINE GENSET PARAMETERS mode. (Note: only while the selected genset
controller is in the AUTO, RUN or FAIL state.)
7 WAVENET REMOTE PANEL
7.1 ON-LINE GENSET STATUS MODE
This is used to distinguish WaveNet controlled gensets on the WaveNet Remote display. The
genset controller’s name is a maximum of 9 letters and should be assigned by the user from each
genset controller. The WaveNet Remote will display “NORTH-nnn”if the local WaveNet
controller
has not had a name assigned;
the nnn represents the local WaveNet
controller’s NMEA 2000
®
address. For
example a genset controller with address
29 would be displayed on the WaveNet
Remote LCD as “NORTH-029”. A “-----”
indicates there is no on-line genset
controller for that position.
7.1.1 GENSET CONTROLLER’S NAME
The state of each genset will be one of the following:
AUTO
,
RUN
,
FAIL
,
OFF
or
MENU.
AUTO
- The local WaveNet panel is in the AUTO mode and the genset can be started from any enlisted
WaveNet Remote by pressing the Start key. See Remote Unit Settings, Advanced Setup, section 7.1, for
enlisting instructions.
7.1.2 STATE
updated 1-20-12