Northern Lights Lugger M944W, Руководство по сборке

Страница: 8 / 12

10
6
Figure 6: Facing the rear panel.
Install connections for exhaust, fuel, AC power leads, DC control panel leads, battery,
and water through holes in the rear panel as shown in the drawing (Figure 6) and as
described below:
a. Connect the exhaust elbow of the diesel engine to the exhaust system of
the vessel. Pass the three inch exhaust hose through the opening provided
in the left mid-section of the rear panel.
b. Connect the sea water pump to the vessel’s water inlet. Pass a 3/4” hose
from the vessel’s sea water strainer, through the lower hole at the bottom
left of the rear panel to the sea water pump inlet fitting.
c. Connect the vessel’s fuel supply, and fuel return to the generator set using
Coast Guard approved rubber fuel hoses. Pass these lines through the hole
provided at the bottom left of the rear panel and attach them to the
generator set’s 1/4” hose barb fittings.
d. Connect the DC control harness to the engine harness plug. Pass the
harness and plug through the top hole on the right side of the rear panel.
e. Connect the 12 volt battery leads to the generator set using the second
hole above the bottom right side of the rear panel.
f. Connect the AC output leads from the generator to the vessel’s power
distribution panel. Pass the two leads through the second hole from
the bottom left side of the rear panel.
g. For optional equipment, leave plug installed.