Northern Lights Lugger M944W, Руководство по сборке

Страница: 6 / 12

6
Take the pre-assembled enclosure top (Items 3, 4, 5, 7, 8, 16, 17, 18, 19 and 22)
and note the available leg on each of the cast corners (Item 7). Install a bolting
assembly (Item 8) to each of these legs. See Figure 2.
Figure 2: Internal view of corner casting,
part of the pre-assembled top enclosure
frame assembly.
Note arrangement of bolting assembly.
4
Figure 3: Note how the bolting assembly
fits inside the vertical extrusion. Only finger
tighten until all four corners have been fully
installed.
Make sure that you have the end with the triangular shaped penetration plate
(item 18) at the forward left hand corner of the genset. Then take the enclosure
top assembly and position it so that the legs are facing down and install each
of the legs into the top of each vertical extrusion. You may wish to temporarily
remove the top panel assemblies (items 16 & 17) and set them aside for now to
help improve visual and manual access to the bolting assemblies and for step 8.
See Figure 3.
7