Northern Lights Lugger M944W, Руководство по сборке

Страница: 7 / 12

9
After the basic frame is complete, install the rear panel assembly (item 10) to
the rear of the enclosure frame and secure using the pre-installed panel retainer
brackets (item 19) and 1/4-20 nylock nut (item 22). Ensure that the panel is prop-
erly fitted into the back of the frame, with the panel surface to extrusion being
flush. Take the panel retainer bracket (item 19) and rotate it until it is directly on
top of the extrusion flange and then tighten down the 1/4-20 nylock nut so the
retainer effectively clamps the panel against the extrusion flange.
Note: the black intake hose strapped to lower left hand side of generator; when
rear panel is fully installed just push the open end of this hose into the hole as
shown in the diagram.
Once all four corners of the enclosure top frame assembly have been
attached, install the left and right side vertical center posts (item 6) by aligning the
center post foot mounting holes to the pre-drilled holes at the side mid-section of the
base board. See Figure 4.
Use the #10 screws (item 20) to secure the center post to the base board. Then locate
the stud at the top of the center post of the previously installed tie bracket (item 9),
and secure it with 1/4-20 nylock nut (item 22). See Figure 5.
Do not tighten fully until remaining panels can be installed for clearance adjustment.
8
5
Figure 4: Vertical side posts. Figure 5: Top frame assembl y.