l
Before operating the band saw EACH TIME
, check for alignment of moving parts; binding of moving
parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other
Part that is damaged should be properly repaired or replaced.
l
Never leave saw
running unattended.
l
When moving the saw, ALWAYS
have the head lowered to the horizontal position.
IMPORTANT:
Coolant pump motor voltage must always be the same as machine motor voltage.
l
Saw Base Assembly
l
Tools required for assembly
1.#2 cross point screwdriver
2.Pliers
l
Unpacking and clean-up
1.Uncrate the saw. Inspect it for shipping damage. If any damage has occurred, contact Northern Tool at
1-
800-222-5381
.
2.Unbolt the saw from the skid and place it on a level surface.
3.Clean rust protected surfaces with kerosene, diesel oil, or a mild solvent. Do not use cellulose based
solvents such as paint thinner or lacquer thinner. These will damage painted surfaces.
1.Place blocking under the ends of the saw base to allow wheel installation.
Caution: Make sure saw is steady while temporarily supported.
2.Slide wheel axles through holes in base.
3.Slide wheel onto axles and fasten with pins. Bend pins to hold in place.
4.Slide material stop rod (#74) into base and secure by tightening
hex.hd screw (#71). Slide material stop block(#73) onto rod and
tighten thumb screw (#72).
5.Slide blade back cover(#128) over pulley assemblies and fasten with
plum screw(#130)and washer (#130-1).
6.Close belt cover and secure with lock knob (#131).
7.Remove transportation strap and keep for later use should the saw be
Moved any distance.
Vertical cutting plate assembly
Note
: these steps are only necessary if using the band saw in the vertical
Mode.
WARNING:
Disconnect band saw from the power source before
making any repairs or adjustments.
1.Raise the arm to the vertical position and lock in place by turning the
hydraulic cylinder valve to the off position.
2.Remove two screws (A, Fig. 3) and the deflector plate (B).
3.Guide blade through slot in table and fasten with two screws.See Fig. 4.
Fig.3
Fig.4
3 OF 15