Assembly and Initial Set-Up
14
Step 3. Initial Pump & Engine Preparation
Prepare
Water Pump
Verify pump oil level
.
Note: The pump is shipped with oil.
1.
Verify that oil level is half way up the sight glass (or at the indicator line on
the dip stick).
2.
If oil level is low, fill using the type of pump oil specified below:
(See "Specifications" section of this manual to determine the type of pump
that came equipped with this pressure washer.)
a.
For Comet or NorthStar pumps: Use Universal Tractor
Transmission Oil or Non-detergent 30 weight oil.
3.
Replace fill cap.
Prepare
Engine
Fill the engine with oil
.
Note: The engine is shipped without oil.
Refer to the Engine Manual to locate oil-fill port and for instructions on filling.
Use the oil grade and quantity specified in the Engine Manual.
Figure 5
Oil drain plug
Sight glass
Oil fill
Содержание M157593E
Страница 51: ...Parts Explosion M157593 Rev E 51...
Страница 55: ...Wiring Diagram Rev E 55...
Страница 62: ...62 Manufactured by Northern Tool Equipment Co Inc Burnsville MN 55306 NorthernTool com...