69
Assembly Instructions
Hose Clamp
Hose Clamp
Hose Guide
Tow Bar
Suction Hose
Tools Needed
Flat Blade Screw
Driver
Pipe Wrench
Torque Wrench
Step 19 – Suction Hose Routing
Screw finger-tight (1) Filter Fitting into the return line filter head
Wrench-tighten the fitting to 1.5-3.0 Turns Past Finger Tight position.
Consider final orientation position as to not exceed the recommended
TPFT. Properly assembled fittings total thread engagement should be
3.5-6 turns.
CAUTION: Never back off an installed pipe fitting to achieve proper
alignment. Loosening installed pipe fittings will corrupt the seal and
contribute to leakage and failure.
Add hose clamp and connect one end of the suction hose to the Valve
to Hydraulic Tank Fitting. Torque to 77 in.-lb.
Route hose as shown below
Add hose clamp and connect remaining end of suction hose to Return
Line Filter Fitting. Torque to 77 in.-lb.
Fittings Needed from Parts Bag:
Filter Fitting
Return line
Filter Head
Valve to Filter
Hose Clamp
Qty 2
1131 Only
Содержание M110800F.4
