68
Assembly Instructions
Hose Needed:
Tools Needed
1” Wrench
7/8” Wrench
OR
Crescent Wrench
(2 Needed)
Step 18 – High Pressure Hose Routing Cont’d
Remove plug from pump.
Screw finger-tight (1) Hydraulic Pump Fitting into the pump
Wrench-tighten the fitting to 1.5-3.0 Turns Past Finger Tight position.
Consider final orientation position as to not exceed the recommended TPFT.
Properly assembled fittings total thread engagement should be 3.5-6 turns.
CAUTION: Never back off an installed pipe fitting to achieve proper
alignment. Loosening installed pipe fittings will corrupt the seal and
contribute to leakage and failure.
Route (1) Long High Pressure Hose from the Valve to Hydraulic Pump
Fitting on the control valve to the Hydraulic Pump Fitting
Screw finger-tight Long High Pressure Hose to Valve to Hydraulic Pump
Fitting
Wrench tighten 1.5-3.0 Turns Past Finger Tight
Screw finger-tight remaining end of Long High Pressure Hose to the
Hydraulic Pump Fitting
Wrench tighten 1.5-3.0 Turns Past Finger Tight
Valve to Hydraulic Pump
High Pressure Hose, 56” x 1/2” ID with
1/2” Male NPT fittings
Qty 1
Valve Fitting
Long High
Pressure Hose
Tow Bar
Hose Guide
Hydraulic Pump
Pump Fitting
Pump Pump Fitting
Remove
plug
Содержание M110800F.4
