Nortel CallPilot 150, Руководство по установке и обслуживанию

Страница: 24 / 94

24 Chapter 4 Installing CallPilot Mini/CallPilot 150
P0990474 0
3
Connecting the CallPilot Mini/CallPilot 150
1 Open the CallPilot Mini/CallPilot 150 by inserting a flat screwdriver into the slot on the
right-hand side of the door and pressing the tab out of the way.
Figure 3 shows the inside of the CallPilot housing and points out the cable jacks.
2
Connect a TCM cable to Port A and to Port B.
Table 5 shows the pin out of Port A and Port B.
3
Connect the other end of the TCM cables to station ports on your telephone system.
4 Connect the power cable to the CallPilot Mini/CallPilot 150 and the wall socket.
5
Run all the cables through the cable trough at the top of the CallPilot Mini/CallPilot 150.
6 If you are installing a CallPilot Mini system, attach the EMC Kit around all four of the
CallPilot Mini cables. The EMC Kit must be fully closed and attached at the point where the
cables exit the CallPilot Mini.
Figure 4 shows the EMC Kit and where it is attached.
7
Close the lid.
Table 5 Port A and Port B Pinouts
Pin number Port A Port B
1 no connection no connection
2 TCM 3 TCM 4
3 TCM 1 TCM 2
4 TCM 1 TCM 2
5 TCM 3 TCM 4
6 no connection no connection
Note:
Do not connect the Ethernet cable for your LAN to the Ethernet port until you
determine if the CallPilot Mini/CallPilot 150 IP address is compatible with the
network. For information about the default CallPilot Mini/CallPilot 150 IP address
and how to change the IP address, refer to
“Connecting to the CallPilot Mini/CallPilot
150” on page 35 .
Note: The EMC Kit must be around the power, Ethernet and two TCM cables in order
to achieve Class B Homologations.
If you use cables other than the ones supplied with the CallPilot Mini, make sure all
four cables fit inside the EMC Kit and the EMC Kit can be fully closed.