Securing your system
75
snmp-server host for the new-style table command
The
snmp-server host
for the new-style table command adds a trap
receiver to the new-style configuration (that is, to the SNMPv3 tables). You
can create several entries in this table, and each can generate v1, v2c, or
v3 traps. You must previously configure the community string or user that
is specified with a notify-view. The syntax for the
snmp-server host
for the new-style table command is:
snmp-server host <host-ip> [port <1-65535>]
{<community-string>|v2c <community-string>|
v3 {auth|no-auth|auth-priv} <username>}
The
snmp-server host
for the new-style table command is executed in
the Global Configuration command mode.
Table 34 "snmp-server host for the new-style table command parameters
and variables" (page 75)
describes the parameters and variables for the
snmp-server host
for the new-style table command.
Table 34
snmp-server host for the new-style table command parameters and variables
Parameters and variables
Description
<host-ip>
Enter a dotted-decimal IP address of a host to
be the trap destination.
port
<1-65535>
Sets SNMP trap port.
<community-string>
If you do not specify a trap type, this variable
creates v1 trap receivers in the SNMPv3 MIBs.
You can create multiple trap receivers with
varying access levels.
v2c <community-string>
Using v2c creates v2c trap receivers in the
SNMPv3 MIBs. You can create multiple trap
receivers with varying access levels.
v3 {auth|no-auth|
auth-priv}
Using v3 creates v3 trap receivers in the
SNMPv3 MIBs. You can create multiple trap
receivers with varying access levels by entering
the following variables:
•
auth|no-auth
—Specifies whether
SNMPv3 traps can be authenticated.
•
auth-priv
—This parameter is only
available if the image has full SHA/DES
support.
Nortel Ethernet Routing Switch 2500 Series
Security — Configuration and Management
NN47215-505 (323165-B)
02.01
Standard
4.1
19 November 2007
Copyright © 2007, Nortel Networks
.
