Nortek Reznor RHC DJL 8000, Установка, пусконаладка, обслуживание

Страница: 6 / 42

Page 4 RHC 8000 EN April 2019 D301207 Issue C
• In case of persisting problems,contact
your distributor
• The electrical isolator should only be
used in an emergency and should not be
used for closing down the main burner,
as it switches off the fan prematurely
and may damage the heat exchanger,
invalidating the warranty.
• The temperature in the control section
of the unit may never be less than-10°C
otherwise damage could occur to the
sealing elements of the gas valve and to
the electronic components.
Contained within the text of the manual,
the words ‘Caution’ and ‘Warning’ are
used to highlight certain points.
Caution is used when failure
to follow or implement the
instruction(s) can lead to
premature failure or damage to
the heater or its component parts
Warning is used when failure to
heed or implement the
instruction(s) can lead to not only
component damage, but also to a
hazardous situation being created
where there is a risk of personal
injury.
1. Introduction
Isolate any electrical supply to the heater
and controller before proceeding.
1.1 Basic Information
The instructions in this manual apply to the
RHC8000(M) DJL gas-fired/ fan-assisted
warm air heaters: installed at an operational
ambient temperature between -15°C and
+45°C.
The appliances must be installed in
accordance with the rules in force. Before
installation, check that the local distribution
conditions,nature of gas and pressure and
adjustment of the appliance are compatible.
A permanent electricity supply of 230
volts,50Hz,single phase is required.
• Gas categoriesI2H,I2E,I2E(S),I2E(R), I2Esi,
and I2EK
• RHC 8000(M) DJL model suitable for
indoor air handlers only(when installed
where the height above floor level is
greater than 1,8 meters measured to the
underside of the appliance they may be
used as a garage air heater).
Model RHC 8000(M) DJL heaters are
approved for:
Type B 22/B52 – vertical vent (through the
roof) or horizontal vent (through the wall)
All models & sizes are available for use with
natural, gas with operating temperatures
between 15°C and 40°C.
These instructions are only valid for
appliances designed to operate in Europe.
If the country code and gas category on
the appliance data label does not match
the country of installation or the country
codes and gas category’s as shown in this
instruction manual, it will be necessary to
contact the distributor or manufacturer
to provide the necessary information
for the modification of the appliance to
the conditions of use for the country of
installation.
Check that the local distribution conditions
of electricity supply, type of gas and
pressure of the appliance are compatible.
The total installation should be installed in
accordance with the rules in force, relevant
National Standards, local regulations,and
Codes of Practice.
When the external control calls for heat,
an electronic control begins the ignition
sequence to provide for a safe start.
Under normal conditions the fan motor runs
constantly and after a call for
heat it switches the heater on through a
CAUTION
WARNING