Nortek Reznor FSE 100, Установка, пусконаладка, обслуживание

Страница: 23 / 53

Reznor, FSE, Installation Manual, EN 2020-02, D301160 Iss H
• The flue duct cannot rest on the
appliance.
• The flue must reach the minimum
pressure required by the current
technical standards, considering “zero”
pressure` to the connection with the
flue duct.
• Unsuitable or wrongly sized flues
or flue gas pipes might amplify the
burning noise and negatively effect the
combustion parameters.
• Joint seals should be made of materials
resistant to the thermal and chemical
stress caused by the combustion
products.
• If walls and/or covers have to be
crossed, this operation should be
carefully carried out, preventing seepage
or risk of fire
• Do not use plastics pipes
Recommend to:
• Avoiding long runs of horizontal flue.
• Using metal pipes with a smooth
surface that are capable of resisting the
thermal and chemical stress caused by
combustion products, with the same
diameter as the connector of the heater
or larger
• Avoid narrow bends and section
reductions;
• Having a trap to take and analyse the
combustion products;
• Anchoring the flue gas discharge pipe
• Having a proper end cover to prevent
rainwater seepage into the heater and
causing significant friction losses.
Condensate Drain
A condense drain with trap should be fitted
to the flue tee piece supplied with the
heater as shown in figure 9 fixing 1 this is
not supplied by the manufacturer
Condense disposal should be in line with
any local requirements or codes of practice
Figure 9 Flue gas discharge
WARNING
The flue pipe connecting the
heater to the flue should be easily
dismantled; to allow users to
easily control and clean inside the
heat exchanger
Combustion air
• The appliance must be installed in
accordance with the regulations in force
and be used only in a well ventilated
area.
• The combustion air inlet is always far
away from any obstacles (leaves, sheets
of paper, nylon, etc.)
• Proper air openings should be made in
the building, to comply with relevant
standards for ventilation.