Nortek Security & Control Gocontrol GC-TBZ48L, Руководство по установке и эксплуатации, Страница: 26 / 32

24 Copyright © 2017 Nortek Security & Control
Clock Menu
Use the clock menu to set thermostat’s internal clock.
Figure 26. Clock Setup
Se ƫ ng the Clock
1. Press any bu on to take thermostat out of sleep mode.
2. Press
FAN bu on for 5 seconds un l, SETUP appears in status display line.
3. Use bu ons to select CLOCK in status display line.
4. Press SELECT , DAY will be displayed
5. Press bu ons, TIME will be displayed.
6. Use the bu ons to select the current me.
7. Press SELECT , DONE , DONE .
INFO Menu
The INFO menu displays informa on about the thermostat. Use the bu ons to scroll through
the various items.
• MODEL NTBZ48
• VERSION Thermostat fi rmware version.
• Z-WAVE Z-Wave fi rmware version.
• NODE ID Z-Wave Node ID.
• HOME ID Z-Wave Home ID.
• SYSTEM TYPE displays current System Type se ng.
• If System Type = Standard, FAN TYPE displays current Fan Type se ng.
• If System Type = Heat Pump, CHANGEOVER TYPE displays current Change Over se ng.
• Ba ery xx% = Ba ery Level (If ba ery powered)
Factory Reset
WARNING: Please use this procedure only when the Z-Wave Primary Controller is
missing or otherwise inoperable.
To reset the TBZ48L's Z-Wave parameters to Factory Se ngs (both Z-Wave and HVAC se ngs):
1. Remove power from the TBZ48L.
2. Hold down the MODE and FAN bu ons simultaneously while powering up.
3. Release when RESET appears on the Status Line.
4. Once the TBZ48 resets the Z-Wave and HVAC se ngs, a DONE con
fi rma on message will
appear on the screen before the thermostat self-reboots.
MODE
FAN
Select
Done
CLOCK
USE THE
BUTTONS TO CHANGE
TO THE DESIRED MENU
ITEM, THEN PRESS
SELECT
MENU CHOICES
ARE DISPLAYED IN THE
STATUS DISPLAY LINE
PUSH AND HOLD
FOR 5 SECONDS
76