Nortek Security & Control Gocontrol GC-TBZ48L, Руководство по установке и эксплуатации

Страница: 17 / 32

Copyright © 2017 Nortek Security & Control LLC 15
Advanced Z-Wave® Information
This document is for the advanced user who has knowledge of the Z-Wave™ Command Classes. The
GC-TBZ48 can operate as a FLiRS Device. If 24VAC is detected at the me of install the GC-TBZ48L will
be installed as a LISTENING node, otherwise it will be a NOT_LISTENING node if ba ery powered.
Support for Associa Ɵ on Groups
The GC-TBZ48L supports 3 groups and 5 associa ons per group.
Group 1 Associa on is the default status report channel in Z-Wave+ lifeline requirements. Group 1
Alerts are to no fy an associated device of a thermostat generated change. Thermostat generated
changes are those changes that originate at or by the thermostat. The following Command Classes
can be sent to the lifeline:
• BATTERY_REPORT
• DEVICE_RESET_LOCALLY_NOTIFICATION
• SENSOR_MULTILEVEL_REPORT
• THERMOSTAT_SETPOINT_REPORT
• THERMOSTAT_SETPOINT_MODE
• THERMOSTAT_FANMODE_REPORT
• THERMOSTAT_FANSTATE_REPORT
• THERMOSTAT_OPERATINGSTATE_REPORT
• THERMOSTAT_CONFIGURATION_REPORT
Group 2 Associa Ɵ on Alerts will send a BASIC_SET 0xFF when a Cool Call starts and a BASIC_SET 0x00
when the Cool Call ends.
Group 3 Associa Ɵ on Alerts will send a BASIC_SET 0xFF when a Heat Call starts and a BASIC_SET 0x00
when the Heat Call ends.
Clock Menu
Use the clock menu to set thermostat’s internal clock.
Figure 17. Clock Setup
Se ƫ ng the Clock
1. Press any bu on to take thermostat out of sleep mode.
2. Press
FAN bu on for 5 seconds un l, SETUP appears in status display line.
3. Use bu ons to select CLOCK in status display line.
4. Press SELECT , DAY will be displayed
5. Press bu ons, TIME will be displayed.
6. Use the bu ons to select the current me.
7. Press SELECT , FAN (Done), FAN (Done).
MODE
FAN
Select
Done
CLOCK
USE THE
BUTTONS TO CHANGE
TO THE DESIRED MENU
ITEM, THEN PRESS
SELECT
MENU CHOICES
ARE DISPLAYED IN THE
STATUS DISPLAY LINE
PUSH AND HOLD
FOR 5 SECONDS
76