Copyright
©
2020 Nortek Security & Control
23
22
Copyright
©
2020 Nortek Security & Control
Setting the Fan Mode
Figure 23.
Fan Setting
Fan Modes
Use the
FAN
button to cycle the HVAC system’s fan modes.
•
Auto:
Fan automatically operated by the HVAC system (normal setting).
•
On:
Manual Fan mode. Fan stays on until mode is changed back to
Auto
, independent of the
heating or cooling system operation.
Note:
Fan Off
mode is not supported by the thermostat. The off command from Z-Wave controller/
gateway will be ignored.
User Customization
Figure 24.
Selecting Menu Mode
Figure 25.
Menu Navigation
User preference settings.
•
FAHRENHEIT* OR CELSIUS. Select the temperature display mode.
•
BACKLIGHT TIMEOUT. Sets the time from last button touch that the backlight will turn OFF.
Range: 10-30 seconds. Default is 20* seconds.
Note:
Long backlight timeouts will reduce battery life.
•
SENSOR CALIBRATION Change the temperature calibration by +/- 7 degrees. Default is 0*. Touch
the UP or DOWN arrow buttons to change to the desired display temperature.
•
STATUS LINE. Sets Status Line to Setpoints* or Clock information.
* = Default
Off
65
Fan Auto
SET 70
TOUCH TO CHOOSE
FAN
ON
OR
FAN AUTO
F
41
%
Select
Done
TO SELECT THE
MENU MODE, TOUCH
AND HOLD THE
MODE
BUTTON UNTIL THE
SETUP SCREEN IS
DISPLAYED
S E T U P
TOUCH
MODE (Done)
TO EXIT BACK TO THE
MAIN THERMOSTAT
SCREEN
TOUCH
FAN (Select)
TO
ENTER THE DISPLAYED
MENU
MENU CHOICES ARE DISPLAYED IN THE
STATUS DISPLAY LINE
TOUCH THE
▲▼
BUTTONS TO CHANGE
TO THE DESIRED MENU
ITEM, THEN TOUCH
FAN (Select)
Select
Done
S E T U P
