NORSELIGHT 4036538577789, Инструкция по установке и эксплуатации

Страница: 34 / 39

34
5.2 Lamp replacement
7. Use a fl at screwdriver to
release the connector
6. Loosen the bolt holding the positive (+) lamp connector
5. Remove the bracket
4. It might be necessary to use a small screwdriver to loosen
the bracket.
2. Remove the 4 nuts (6 for the bigger lamps) that are holding
the front glass
3. Loosen one bolt, and remove the othebolt fi xing the lamp holder
bracket.
Note! It is not necessary to loosen the white lampholder from the
bracket.
If this have been loosened or adjusted, it is important that the lamp
has approximate 1 to 1,5mm of free running space.
See the picture on part number 12 in this document.
1. Turn o ff the fuse to the power-supply/recti fi er and make sure
nobody can turn it on during the replacement of the lamp.
Allow the lamp to cool down.
Use safety equipment. Face cover and Gloves and are a minimum.
Caution! Because of its high internal pressure, there is a risk that
this lamp will explode in either the hot or cold state.
It is very easy to see were the bracket was mounted,
make sure to put it back in the same position when the lamp
is replaced.