Norelco 422203610380, Руководство пользователя

Страница: 9 / 21

Do not clean more than one cutter and comb at
a time since they are all matching sets. If you
accidentally interchange the cutters and combs, it
could take several weeks before optimal shaving
performance is restored.
C
6 Cutter should be held with cutters facing
up and brushed in an upward motion.
Clean razor comb with long bristles of
brush in a circular motion.
For optimum performance, razor cutters and
combs should be cleaned in a degreasing liquid
(e.g., Norelco Razor Cleaner, model RC1776, or
alcohol) and lubricated with Norelco Razor
Lubricant, model AL80, or one drop of mineral oil
(in the center of the head).This helps prevent
wear of shaving heads.
C
7 While holding Razor Head Assembly in
one hand, replace cutter and comb back
into the Razor Head Assembly.
8 Repeat the process for the other two sets
of cutters and combs.
C
9 Replace frame back into Razor Head
Assembly.While pressing down, turn wheel
clockwise to lock frame into place.
10 Press Razor Head Assembly back on razor.
11 Put the protective razor head cap on the
razor to protect heads.
ENGLISH
17
ENGLISH
16
6 Open the Razor Head Assembly and leave
it open to let the Razor air dry completely.
Every Two Months: Razor Heads
IMPORTANT: Do Not mix up the cutters
and combs as the shaving performance may be
adversely affected for several weeks before
optimal shaving performance is restored.
1 Switch razor OFF.
C
2 Press the Razor Head Release Button
located under razor heads on front side of
Razor.
C
3 Remove the Razor Head Assembly and
clean the razor heads and hair chamber by
running under hot water. Be sure water is
not too hot so as to cause burns or
scalding.
C
4 While holding Razor Head Assembly in
one hand, press center wheel down while
turning counterclockwise to release and
lift out frame. Set frame aside.
C
5 Remove and clean one cutter and comb, at
a time.
2
1
1
2
1
2