Nordson Versa-Spray II, Руководство пользователя по изделию

Страница: 19 / 64

Operation
4-3
Part 107016-02
E
2016 Nordson Corporation
Daily
See Figure 4-1.
1. Disconnect the powder feed hose from the pump. Blow the powder out
of the hose and spray gun with an OSHA-approved low-pressure air
gun. Never blow air through the powder feed hose from the spray gun
into the pump.
2. Remove the nozzle parts (4 − 6), set screw (7), and powder inlet body (3)
from the spray gun. Clean them with a low-pressure air gun. Wipe the
parts with a clean, dry cloth.
3. Blow powder off the resistor probe (2) and multiplier (1). Wipe them with
a clean, dry cloth.
4. Carefully remove fused powder from the parts with a wooden or plastic
dowel or similar tool. Do not use tools that will scratch the plastic.
Powder will build up and impact-fuse on scratches.
1400412B
1
2
3
4
5
6
7
8
Figure 4-1 Disassembling the Gun for Cleaning (Gun with Air Shown)
1. Multiplier
2. Resistor probe
3. Powder inlet body 4. Wear sleeve
5. Optional nozzle adapter
6. Flat-spray nozzle 7. Set screw
8. Hose adapter
Note: Item 4 is not used on guns that have an optional nozzle adapter.