11
9
92
74
73
9.
Tighten the 3/8" x 5" Bolts (7).
Attach the Console Cover (73) to the top of the
Upright (74) with two #8 x 1/2" Cover Screws
(92).
Do not overtighten the Screws.
10.
Make sure that all parts are properly tightened before you use the incline trainer.
Keep the included hex
keys in a secure place. A hex key is used to adjust the walking belt (see pages 22 and 23).
To protect the
floor or carpet from damage, place a mat under the incline trainer.
7
1
Receiver
90
90
1.
Make sure that the power cord is unplugged.
Remove the indicated #8 x 3/4" Screw (1) from
the Access Door (90) on the back of the Console
(84).
2.
See the lower drawing. Hold the receiver so
that the antenna is oriented as shown.
Peel
the paper backing off the back of the receiver.
Press the receiver onto the Access Door (90) in
the location shown.
3. Connect the wire on the receiver to the wire ex-
tending from the Console (84).
Make sure that
no wires are pinched.
Reattach the Access
Door (90) to the Console with the #8 x 3/4"
Screw (1). Discard the other wires included with
the receiver.
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
Antenna
84
Wires
