9
6. Remove the elastic bands securing the Upright Wire (75)
and the TV Cable (110). Next, insert the Upright Wire and
the TV Cable through the Handrail Spacers (95) as
shown, and press the Handrail Spacers into the tops of
the Uprights (73, 74).
With the help of a second person, hold the console as-
sembly near the Uprights (73, 74). Connect the Upright
Wire (75) to the wire harness on the console assembly.
Make sure to connect the connectors properly (see
the inset drawing); the connectors should slide to-
gether easily and snap into place.
If the connectors do
not slide together easily and snap into place, turn one
connector and try again.
IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.
Next, connect the TV Cable (110) to the cable on the left
side of the console assembly.
Insert the Upright Wire (75) and the TV Cable (110)
down into the Uprights (73, 74). Next, insert the brackets
on the console assembly into the Uprights.
Be careful
not to pinch the wires.
Console
Assembly
Cable
73
Console
Wire
95
75
74
6
95
110
7. Finger tighten three Handrail Bolts (64), with three
Handrail Star Washers (90), into the Right Upright (74)
and console assembly. Repeat with the Left Upright (73).
After all six Handrail Bolts have been started, tighten
the four front Handrail Bolts before tightening the
other two Bolts.
7
Console
Assembly
90
64
90
73
74
64
75
5. Remove the Spring Pin (102) from the lower end of the
Gas Spring (88).
Next, press the lower end of the Gas Spring (88) onto the
ball on the bracket on the Base (83). If necessary, pivot
the Frame (48) slightly and rotate the Gas Spring to align
the end of the Gas Spring with the ball on the bracket.
See drawing 5a. Insert the end of the Spring Pin (102)
into two of the small holes in the end of the Gas Spring
(88). Then, rotate the Spring Pin until it clips onto the
Gas Spring.
Carefully lower the Frame (48) to the floor.
88
102
88
102
5
83
48
Bracket
Bracket
5a
