Norco Eco-Stim NC89481, Инструкция по эксплуатации, Страница: 17 / 23

Malfunction Common reasons Countermeasure
No display
after
replacing
the
batteries
1. There’s foreign matter in
the battery compartment.
2. The batteries are dead or
installed incorrectly.
3. There’s foreign matter in
the battery interface.
4. The batteries are not the
right model or something
is wrong with the battery
interface.
5. Exception reset
1. Check and clean the
compartment.
2. Replace with new
batteries or install the
batteries correctly.
3. Check and clean the
interface.
4. Replace the batteries with
the right model.
No
sensation
of
stimulation
1. The electrode is not
connected to the skin well.
2. The electrode wire is not
plugged into the unit.
3. The batteries are dead.
4. The skin is too dry.
1. Check and re-apply to skin.
2. Check the connection.
3. Replace the batteries.
4. Wipe the electrode and
the skin with a wet
cotton cloth.
Automatic
halt in the
treatment
1. The electrode loses
connection with the skin.
2. The batteries are dead.
1. Check and place the
electrode properly on
the skin.
2. Replace the batteries.
Rash or tickle
on the
skin occurs
in the
treatment
1. The treatment time lasts
too long.
2. The electrode is not in
good contact with the skin.
3. The interface of the
electrode is dirty or dry.
4. The skin is sensitive to
the electrode.
1. Do the treatment once a
day and shorten the
treatment time.
2. Stick the electrode to the
skin better
3. Wipe the electrode
with a wet cotton cloth
before use.
4. Check your allergic history.
Change the electrode
location or shorten the
treatment time. If your skin
is over-sensitive, stop the
treatment or see a doctor.
33 32
4) Clean the surface of the electrode pads carefully with a
damp cloth after making sure the device is turned off.
5) For best hygiene, each user should use his/her own set
of electrodes.
6) Do not use any chemical cleaners or abrasive agents
for cleaning.
7) Ensure that no water penetrates into the device. Should this
happen, use the device again only when it is completely dry.
8) Do not clean the device during treatment. Be sure that the
device is turned off before cleaning.
7.2 Maintenance
1) The manufacturer has not authorized any maintenance
agencies. If your device has any problems, please contact the
distributor. The manufacturer will not be responsible for the
results of maintenance or repairs by unauthorized persons.
2) The user must not attempt any repairs to the device or any of
its accessories. Please contact the retailer for repair.
3) Opening of the equipment by unauthorized agencies is not
allowed and will terminate any claim to warranty.
Each product in manufacturing has been inspected through
systematic validation. Calibration and validation is not required
for this device.
If your product does not reach the expected performance and
the basic function has changed in normal use, please contact
the retailer.
Should a malfunction occur while using the device, check
whether the parameters are set appropriately for therapy,
and adjust the control correctly. Please see the following table:
8. TROUBLESHOOTING