Norco Eco-Stim NC89481, Инструкция по эксплуатации, Страница: 16 / 23

31 30
Usage advice for TENS:
If you feel the output intensity too strong, you can press [-]
button to decrease it.
If you don’t feel any discomfort during the treatment, we advise
you to use the device until the session ends. Normally, the pain
relief occurs after 5-10 min of treatment; Normally, we advise 1-2
treatments per day and one week as a treatment period.
After a treatment period, if pain relief is not achieved or the pain
gets worse, please consult your doctor.
Usage advice for EMS:
Place the electrodes on the body part you want to treat referring
to the picture on Section 5.3.3.
1-2 treatments per day, about one week as a treatment period.
We advise that you use the device for one session per time.
If you feel discomfort during treatment, you can either pause
the session or decrease the intensity of the output.
7) The adhesive force of the electrodes depends on skin
properties, storage condition, and the number of
applications. If your electrode pads no longer fully stick
to the skin surface, replace them with new ones. Stick
the electrode pads back onto the protective foil after use
and store them in the storage bag to prevent them
from drying out. This retains the adhesiveness for a
longer period.
Caution
1) Before applying the electrode, it is recommended that the
user’s skin be washed and degreased, and then dried.
2) Never remove the electrode from the skin while the device
is still on.
3) Only use the electrode pads recommended by the
manufacturer. Use of inferior electrode products could
result in injuries to the user.
6.11 Where do I attach electrode pads?
1) Each person reacts differently to electric nerve stimulation.
Therefore, the placement of the electrodes may deviate
from one person to another. If the application is not
successful, contact your healthcare provider to find out
which placement techniques are best for you.
2) Do not use smaller sized adhesive electrodes than what
was provided by the original manufacturer, otherwise the
current density may be too high and cause injuries.
3) The size of the adhesive pads may not be customized,
e.g. by clipping off parts of them.
4) Make sure that the region radiating the pain is enclosed by
the electrodes. In case of painful muscle groups, attach the
electrodes in such a way that the affected muscles are also
enclosed by the electrodes.
Fully comply with the following necessary daily maintenance
requirements to make sure the device is intact and guarantee
long-term performance and safety.
7.1 Cleaning and care for the device
1) Disconnect the electrodes from the stimulator. Clean the
device with a soft, slightly damp cloth. In case of heavier
dirt build-up, you may also apply a mild detergent.
2) Do not expose the device to moisture or dampness. Do not
hold the device under running water, nor submerge it in
water or any liquid.
3) The device is sensitive to heat and should not be exposed to
direct sunlight. Do not place device on hot surfaces.
7. CLEANING AND MAINTENANCE