Norco Eco-Stim NC89481, Инструкция по эксплуатации, Страница: 10 / 23

19 18
1) If a battery was swallowed accidentally, please seek medical
assistance immediately!
2) In case of battery leakage, please avoid contact with the
battery through skin, eyes and mucus membranes. If contact
occurs, please wash the contacted body part with plenty of
clean water and contact your doctor immediately.
3) Batteries should not be dismantled, thrown into fire or
short-circuited.
4) Protect batteries from excess heat; take the batteries out of the
product if they are spent or you don't use it for a long time.
This can prevent device from damage due to battery leakage.
5) Replace all of the batteries simultaneously.
6) Always use the same type of battery when replacing.
5.2 Connect electrode pads to electrode wires
Insert the electrode wire connector into electrode connector.
Make sure the two components are properly connected to
ensure optimal performance. Please refer to the picture below.
5.3 Connect electrode wires to device
Before proceeding to this step, ensure that the device is
completely switched OFF.
Hold the insulated portion of the electrode wire connector and
insert the connector into the port on the top of the device.
Ensure the electrode wires are inserted correctly. The device
has two output ports controlled by Channel A and Channel B at
the top of the unit. You may choose to use one channel with
one pair of electrode wires or both channels with two pairs of
electrode wires. Using both channels gives the user the advantage
of stimulating two different areas at the same time.
Caution
Do not insert the plug of the electrode wires into any AC power
supply socket.
5.4 Electrode
5.4.1 Electrode options
The electrodes should be routinely replaced when they start
to lose their adhesiveness. If you are unsure of your electrode
adhesive properties, please order new replacement electrodes.
Follow application procedures outlined on electrode packaging
when using the new replacement electrodes to maintain
optimal stimulation and to prevent skin irritation.
5.4.2 Place electrodes on skin
Place the electrode on the body part in need of treatment according
to the instructions provided in this user manual. Cleaning the skin
before use will help ensure the skin and electrode connect well.
Caution
Always use electrode pads which comply with the requirements
of the IEC/EN60601-1, ISO10993-1/-5/-10 and IEC/ EN60601-1-2,
as well as CE and FDA 510(K) regulation.