Norac UC5 CANbus, Быстрое руководство

Страница: 10 / 18

7
5 UC5 Operation
NOTE: Some functions and features may not be available for all sprayer makes and models.
Consult your sales representative or technical support with any questions or concerns.
5.1 Initial Start Up
On the initial startup and after confirming the legal disclaimer, a screen will appear informing
the operator that an automatic setup must be performed. After confirming this screen, the
automatic setup will begin ( Section 6.1 ). The automatic setup reminder at startup will also be
shown each time a firmware update is performed.
5.2 Main Run Screen
Once the system is correctly configured, it is very simple to use. After confirming the legal
disclaimer, the run screen will appear. For a virtual terminal, from the display’s start up screen,
select the UC5™ icon. An image of the boom, with the height of each boom section is displayed
as shown in Figure 2 .
To change between automatic and manual mode, select the corresponding AUTO (A) or
MANUAL (M) button. When the UC5 system is in manual mode, the height displayed under
each boom section is measured from the spray nozzles to the soil (Soil Mode™) or crop canopy
(Crop Mode™ or Hybrid Mode™). If there are five height sensors on the sprayer, the height
displayed is the average for each boom section.
When the UC5 system is in automatic mode, arrows will appear on the screen above or below
the boom sections. These arrows indicate the UC5 system is making a correction to part of the
boom in the displayed direction. Often the correction will be very small and there may not be a
noticeable change in boom position.
Figure 2: NORAC UC5 Run Screen – Manual Mode Figure 3: NORAC UC5 Run Screen – Automatic Mode
The height displayed under the boom in the upper right corner is known as the target height.
This is measured from the spray nozzles to the soil (Soil Mode) or to the crop canopy (Crop
Mode or Hybrid Mode). The crop at the bottom of the screen indicates the mode the controller
is in. If the green line is above the crop, the system is in Crop Mode. If the green line is below
AUTO
Button
MANUAL
Button
Settings
Button
Boom
Height
and
State