Take off locker
Locker
Locker
A: Major water level adjustment
Loosen the inlet body by
turning slightly anti-clockwise,
Adjust it up or down to correct
position and tighten clockwise.
Re-insert the locker
Slide the locker to "unlock" position,
Move the stop float up/down.
B: Minor water level adjustment
Locker
Stop
Float
F
1x
1x
1x
2x
1x
Parts Supplied:
Inlet Valve
Button
1 - 7
Flush Valve
Flush Cone
"Y" scale
Note:
The Inlet Valve should be adjusted for the particular cistern into
which it is being installed.
Please refer to the
Adjustment Instruction
on
page 5
for the
X. Y settings.
The diagrams below show the detailed adjustment method.
1: Inlet Valve scale and adjustment settings
"X" setting
Do not use bleach or bleach based cleaning products in the cistern, as these will cause damage to the seals.
We cannot be held responsible or liable for any failure which results from the use of bleach based products.
Please read these instructions carefully to avoid damage to the valves, and to ensure correct installation.
Water temperature range +2C to +45C.
Water pressure 0.2 to 8 bar.
Bolt
Installation Instruction for
Dual Flush Cistern Fittings SP697
Inlet Valve Installation And Problem Solving
