8
4.
Lower the LEFT boom from its extreme
HIGH position to the BOTTOM of its
travel. Record this time in
Table 4
,
Trial #1 for “Left DOWN”.
Be careful when lowering the
booms so they don’t hit the
ground.
5.
Similarly, record two more time trials
(Trial #2 & #3) for the LEFT boom and
record in
Table 4.
6.
Repeat
Steps 1
through
5
for the
RIGHT, MAIN and ROLL functions.
Your sprayer may not have a
roll feature.
7.
Average the three trials recorded
for each boom movement and
record this calculation in the
“Average Time” slot in
Table 4
.
8.
These “Average Times” now
represent how quickly your system
can react to manual control. In
Section 4.7
, this procedure is
repeated with the UC4+ Spray
Height Control system installed for
comparison and troubleshooting
purposes.
Содержание UC4+ Hardi OEM
