24
16.
Route the CAN Node cable (
C02B
) to
the roll sensors which are installed in
Section 4.4
. Follow existing cables
and/or hydraulic lines.
17.
Connect the 4-pin AMP connectors to
the roll sensors.
18.
Connect the sensor branch cable (
C02
)
to the 4-pin AMP plug on
C02B
(
Figure 28
).
19.
Route the sensor branch cable (
C02
) to
the wing and main sensors and connect
to the sensors. Follow existing cables
and/or hydraulic lines along the boom.
20.
Cable-tie the installed cables every 12
inches.
IMPORTANT:
Provide enough slack in all cables to
account for the movement of the
main section, parallel lift, and
FOLDING boom movement.
Figure 28 – Cable Configurations: C11, C02 and C02B
Содержание UC4+ Hardi OEM
