6
598-1286-01
Note:
When first turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
* resets to Auto Mode at dawn.
Least Sensitive
Most Sensitive
The sensor is less sensitive to motion directly towards it
and more sensitive to motion across coverage area.
Sensor
Motion
Motion
OperatiOn
Mode:
On-Time
Works:
Day
Night
test
5 Seconds
x
x
auto
1, 5, or 10
Minutes
x
Manual
To Dawn*
x
MANUAL MODE
AUTO
TEST
ON-TIME Switch at 1, 5, or 10
minutes
... back on.
1 Second OFF
then
...
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one sec-
ond then back on to toggle between
AUTO and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or
10 position.
MODe sWitching suMMary
Flip light switch off for one
second then back on*
* If you get confused while switching modes, turn the power
off for one minute, then back on. After the calibration time
the control will be in the AUTO mode.
ManuaL MODe
aDjustMent OF cOverage area
The sensor on this light fixture detects “motion” by the
movement of heat across the coverage area. However,
following are examples of objects that also produce heat
and can cause the sensor to trigger:
• Pools of Water
• Air Conditioners
• Dryer Vents
• Animals
• Heating Vents
• Automobile Traffic
If you suspect that a heat source of this type is triggering
the sensor, reduce the sensitivity.
speciFicatiOns
Range ...............................Up to 30 ft. (9.1 m) [varies with
surrounding temperature].
Sensing Angle...................180°
Electrical Load .................Up to 100 Watt Maximum
Tungsten Incandescent
Bulb Type .........................Medium Base, Type “A”, 100
Watt Maximum
Sensor Capacity ................360 Watt (3.0 A) Maximum
Tungsten Incandescent
Power Requirements .........120 VAC, 60 Hz
Operating Modes .............TEST, AUTO, and MANU-
AL MODE
ON-Timer ........................1, 5, 10 minutes
Test Timer ........................5 Seconds
Manual Mode Timer ........Dusk-to-Dawn
