Operators must check the committed file from the OLT to verify whether the corresponding file has
been applied. If an error occurs, contact Nokia for support.
9.4.2
Configuring an ONT using a configuration file via OMCI
1
Generate the TAR file to be uploaded to the OLT.
Using the raw configuration file(s) provided by Nokia, generate the TAR file as follows:
a. On a Linux platform, rename the raw configuration file to adhere to the naming convention,
as described in section
9.3 “Supported configuration file types” (p. 165)
b. Tar the
ABCXXXXVER
raw configuration file:
tar -cf
ABCXXXXVER
.tar
ABCXXXXVER
Where
ABCXXXXVER
Is the name of the file created in step i.
This creates two files:
ABCXXXXVER
and
ABCXXXXVER
.tar.
c. Rename
ABCXXXXVER
to
ABCXXXXVER
.org
d. Remove the “.tar” extension from
ABCXXXXVER
.tar file.
2
Upload the ABCXXXXVER TAR file to the /ONT/ directory in the OLT.
A maximum of 250 files can be kept in the OLT file system.
3
Using OLT commands, download the TAR file to the ONT.
For OLT commands, refer to the , or the
7342 ISAM FTTU Operation and Maintenance Using
TL1 and CLI
.
Please note:
•
pri-cfgfile-pland/dnload
or
sec-cfgfile-pland/dnload
can be 1 to 14 characters.
•
pri-cfgfile-pland
and
pri-cfgfile-dnload
should be the same name.
Examples
Note: X can be 1 or 2 unless specified:
a. If
pland-cfgfileX= Disabled
and
dnload-cfgfileX= Disabled
,
no file will be downloaded to the ONT.
b. If
pland-cfgfileX=FILENAME1
and
dnload-cfgfileX= Disabled
,
FILENAME1 will be downloaded and FILENAME1 will be made active. An ONT reboot is
required.
c. If
pland-cfgfileX=Disabled
and
dnload-cfgfileX= FILENAME2
ONT configuration file over OMCI
ONT configuration file over OMCI
Nokia ONT
Draft
Draft
December 2020
Issue 1
169
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-49348-AAAA-TCZZA