Safety first
57
Safety first
Note
Please read the basic safety guidelines set out below
before beginning any installation work.
y
Make sure that the car ignition is off and disconnect the car
battery before beginning with the installation work and
ensure that it cannot be reconnected inadvertently.
y
Do not smoke when working on the car. Make sure that
there is no source of fire or flame nearby.
y
Take care not to cause damage to electrical cables, fuel or
brake lines or safety equipment during installation work.
y
Make sure not to impact the steering or braking systems or
other key systems essential for proper operation of the car
when installing car phone equipment. Check to make sure
that deployment of the airbag is not blocked or impaired in
any way.
y
RF signals may affect improperly installed or inadequately
shielded electronic systems in motor vehicles (for example,
electronic fuel injection systems, electronic anti-skid
braking systems, electronic speed control systems, airbag
systems). Should you note a fault or change in the operation
of such a system, contact your car dealer.
y
Only use the car phone at an operating voltage of 12 V with
the minus pole earthed. Failure to observe this requirement
may result in damage to the car’s electronics system.
y
Do not operate your car phone off the car battery for a
longer period of time, that is, with the engine switched off,
as this may cause your battery to run dry.
y
In order to comply with RF exposure requirements for
mobile transmitting devices, a minimum separation
distance of 20 cm must be maintained between the antenna
and all persons.
Mounting
Car phone equipment and cable connections
