Nokia 105s, Руководство по установке

Страница: 89 / 112

General Troubleshooting Information
Nokia 105s Gateway Installation Guide 89
To reset the admin password to a default value
Note
You must have local serial access to your gateway console to perform this
procedure. With a keyboard and monitor directly connected to the
gateway, the
boot:
prompt does not appear, and you cannot perform this
procedure.
1. Boot up the gateway in single-user mode by restarting or power cycling
the gateway.
When the
boot:
prompt appears, enter
-s
before the gateway goes into
multiuser mode; you have about 10 seconds to do this.
2. After the gateway boots up, the following text appears:
Enter pathname of shell or RETURN for sh:
Press Enter.
3.
Type
/etc/overpw
at the
#
prompt.
When the response asks if you want to continue, type
y
.
4. The admin password defaults to no password for admin.
Continue to boot to multiuser mode.
5.
Reconfigure the password as you normally would.
Note
Blank passwords are not accepted in Network Voyager. In such cases,
enter the following command to reset the password from the command
line using a blank password:
dbpasswd admin newpassword ""
The two double quotation marks at the end of the command properly
indicate a blank password.
After you execute this command, the system reports that the password
was not successfully changed. However, the password is changed and is
now
newpassword
.