When the level is displayed, it may be edited
by pressing either
^
or
v
. One digit of the
display starts blinking and the level can be
edited as described below in section
Configuration state, editing floating point
numbers. The editing is ended with the
*
button.
Configuration state
Entering
In the normal state, press the
*
and
^
buttons together two seconds.
Select the slot to be configured using the
^v
buttons. The options are Master, Slot A, Slot
B, and Slot C. Enter with the
>
button. The
contents of the menu depend on the card
type installed, and is described in the
chapter of that card type. The Master
configurations affect the user interface and
the math channel, and are described later in
this chapter.
If a password has been set for the
configuration menu, it has to be entered
now. The display will show Cod.0 and waits
for six button pushes. (If the password is
forgotten, it may be reset by keeping
*
and
>
pressed while switching the power supply
on.)
Navigating
The menu is a hierarchical structure. Within
one menu you can move with the
^v
buttons. A submenu is entered with
>
and
exited with
*
.
Editing
Pressing the
>
button shows the value of the
setting and allows editing it.
Most data types
are edited simply with
^v
buttons and exited with
*
.
Floating point numbers
are edited using
the buttons
^v>
. Select the digit to be
edited or the decimal point with
>
and edit it
with
^v
. The first digit can be edited to a
minus sign.
Setting passwords:
First enable the
password by pressing
^
- Set will be
displayed. Then press
>
, and the display
shows Cod.0. Enter a series of six button
presses using freely the four buttons. Then
re-enter the same series. If these matched,
Set is displayed again and you may exit with
*
:llä. The password can not be
******
.
The password is disabled by selecting
v
Off
instead of Set.
Lock and Free
Some items in the configuration and monitor
menus accept Lock and Free commands.
The purpose of these depend on the menu
item.
The Lock command is given by pressing and
holding the
>
button and pressing the
^
.
Before this, the item name must be in the
display, not the value.
The Free command is given the same way
but using
v
instead of
^
.
Exiting
When all is done for this slot, exit from the
menu with
*
button. Select
^v
Save (keep
the changes) or Undo (discard the changes)
14
Master
Slot A
Slot B
Slot C
*+^
>
^
v
Input settings, see
chapter Input card.
Option card settings,
see appropriate
chapters.
User interface settings,
see below.
