Nodal Ninja Fanotec MECHA, Руководство пользователя

Страница: 22 / 109

22
MECHA User’s Guide v.05.4
‒
Single Axis
© 2020 FANOTEC
If we want to do the same tests that we did before with the bu�ons, we
proceed as follows using the UI bu�ons:
• Tap the [Load 1] bu�on to load the preset Bu�on 1 , then tap the [LEFT]
bu�on to execute the preset to the le�, or [RIGHT] bu�on to execute the
preset to the right.
As an alterna�ve, tap the Presets , under [Cancel] , [PAUSE] , [STOP] bu�ons,
and select the Bu�on 1:... from the presets list, then tap the [Load] bu�on,
to load the preset.
Do the same with the Bu�on 2 and Bu�on 3 presets, and use [Load 2] and
[Load 3 ] bu�ons to load them, or select Bu�on 1:.. or Bu�on 2:... from the
presets list, and use [Load] bu�on to load them.
Note how the se�ngs on the Row page change when a preset is loaded. In
other words, the se�ngs we see are, in fact, the loaded preset.
Next, let's do some more simple tests to get acquainted with the interface,
and because we are in the single axis mode, we check that the mode op�on
is
Single , as seen in the images above.
12 shots around to the le�
• Select 12 Shots from the selec�on list between the [LEFT] and [RIGHT ]
bu�ons.
• Note that in the Degrees of rota�on field, 30 ° is automa�cally displayed,
not 90 ° as before. That's because a complete rota�on has 360 degrees.
Without changing any se�ngs, tap the [LEFT] bu�on.
For 12 shots around to the right, tap the [RIGHT] bu�on.