19
28 Check the battery voltage
•
29 Clean and grease the terminals and check for corrosion and damage
•
30 Check the battery housing for damages
•
Charger
31 Check the main power cable for damages
•
32 Check the fail-safe protection during charging
•
Function
33 Check the horn function
•
34 Check the air gap of the electromagnetic brake
•
35 Test the emergency braking
•
36 Test the reverse and regenerative braking
•
37 Test the safety (belly) button function
•
38 Check the steering function
•
39 Check the lifting and lowering function
•
40 Check the buttons on the tiller
•
41 Check whether the key switch is damaged and check the function
•
42 Check the speed limit sensor (lift height >~300mm)
•
General
43 Check if all decals are legible and complete
•
44 Check and ensure that the protection board and/or protections are not damaged
•
45 Check the casters, adjust the height or replace the worn wheel
•
46 Carry out a test run
•
b.Lubricating points
Lubricate the marked points according to the maintenance checklist. The required grease
specification is: DIN 51825, standard grease.
c.Check and refill hydraulic oil
The required hydraulic l type is:
1.
Bearings on load rollers
2.
Mast
3.
Chain
4.
Steering bearing
5.
Gearbox
6.
Side wheel bearing
Fig. 16: Lubricating points
