95
In addition to checking lights and operating conditions, the key switch must be
turned off and disconnect the battery plug before check the electrical system.
Ⅱ、
Check after operation
After the completion of the work remove the dirt on forklift and check the forklift according to
the follow items
:
(1) Check all the parts if there is damage or leakage.
(2) If there is deformation, distortion, damage or breakage?
(3) Add lubricating grease according to the situation.
(4) Let fork upgrade to the max hight for several times after work. (When the daily work is not
up to the fork with the arrival of the maximum height of the situation, it would allow oil flow through
the tanks of the entire journey, to prevent rust.)
(5) Replace the faulty component which caused malfunction during work.
·
A small mistake will cause a major accident. Do not operate or move the forklift truck
before completion of repair work and inspections.
Ⅲ、
Truck cleaning
·Stop the truck at the specified location.
·Pull the parking brake handle.
·Press the emergency stop switch.
·Turn off the key switch and remove the key.
·Disconnect the battery plug.
1. Truck surface cleaning .
·Do not use flammable liquid to clean trucks, take safety measures to prevent short
circuit.
·
Use water and soluble detergent to clean the truck.
·
Clean the oil filler and periphery of grease tap carefully.
If regular cleaning truck, please lubricate timely.
2. Chains cleaning
·Do not use chemical detergent, acids or other corrosive liquid to clean the chain.
·
Place a tank in the bottom of the frame.
·
Use gasoline or other petrochemical derivatives to clean the chain.
·
Do not add any additive when use the steam nozzle cleaning.
·
Dry immediately after cleaning of the chain pin and the water stain on chain surface.
3. Electric system cleaning
·Do not use water to clean the pump control and a variety of connectors, so as not to
cause damage to electrical systems.
Use non-metallic brush or low-power hair dryer, according to the manufacturer instructions to
clean the electrical system; do not move the protective cover.
4. After cleaning
·
Thoroughly dry water stains on the truck (use compressed air as a example).
·
Start the forklift according to the procedures.