16
~,
MODEL
WORKING
WIDTH
(cm)
WEIGHT
(kg)
POWER
REQUIRED (HP)
min – max
HAMMER
NUMBER
BELTS
NUMBER
GRINDING
DIAMETER MAX
Ø
(mm)
NF 2000
200
1250
100-150
36
10
200
The gear box at 1000 rpm is only optional and it is available on all models NF 2000.
During work You have to check that the rotor rests on the ground throughout its length. Check also that the skids
follow the trend of the land.
For this check is sufficient to note the trace left by the passage of the machine on the ground to be as wide as
the machine itself and the most uniform as possible.
WARNING:
Any adjustment should only be performed by qualified personnel.
We not liable for accidents due to lack of staff training.
CAUTION:
The adjustment operations should always be performed with power take off, machine on the ground
and tractor off and the keys must be removed from the control panel.
Cutting height
The cutting height adjustment is done by means of shredder skids. Unscrewing the screws which secure the
skids to the sides and having holes in the highest position, the cutting height is maximum.
The cutting height is rather less and less as You use holes in the lower positions, bringing the rotor to the
ground.
In normal use the machine should set the cutting height to optimal values. Then adjust the machine so that the
cutting tools are separated from the soil around 4-5 cm ..
CAUTION: Always make sure you have tightened all screws previously loosened.
Rear safety door
Adjustments of the rear door is possible due to the rear cylinder which commands it. The position of the casing
can be varied at work by operating the levers which drive the tractor on the distributor.
Depending on the opening we allow the entry of different amounts of material and have varying degrees of
commination. The opening of the door at work does not present any particular risk, but should carefully avoid
using the movement of the hood to cut trees, which function is performed by frame branches abatement
(optional).
Technical data
Adjustment to work
