10
WARNING: The operations preparatory work must be performed with power take-off, machine on the ground
and tractor off and locked.
WARNING: Any operation (connection and start-up and verification movements) should only be performed by
qualified personnel.
It is task of the company, where the machine is operating, properly educate their staff and make available to the
employees themselves this book and any other information on the machine and it operation.
Not liable for accidents due to lack of staff training.
Before starting work, verify that the machine is in order, that lubricating oils are at the correct level, that the
guards are installed and all parts subject to wear and tear are fully efficient.
The preparation and processing of attachment to the tractor must always be performed with power take off,
machine on the ground and tractor off and keys removed from the control panel.
The attachment to the tractor is a dangerous phase. Be very careful to make the whole operation following the
instructions.
The Forestry shredder Nobili S.p.A. can be applied to any tractor equipped with a three-point hitch, PTO and at
least one distributor double effect.
it is necessary to equip the cab and tractor suitable protective forest use (for example network
protection and shatterproof glass back to the cabin, shielding of the lower tractor with removable steel
plates).
You must also verify that the tractor used is suitable and adequate to the task before moving to the operational
phase. Make especially the power of the tractor PTO, which can not be less than that reported in this booklet
under "Technical data".
- It is still essential to try and verify that the tractor used is suitable and adequate to the task before
moving to the operational phase.
TIP
: check and compare the charts of the tractor and your machine NOBILI S.p.A.
Regarding the use of the tractor, refer to the instructions of that tractor.
Before the attack, always check that the machine is at rest resulting in stable and well on the ground, for this see
chapter "Provisions of the end of work".
The machine comes with a card with the appropriate safety devices.
Before connecting you must still check the length of the shaft. With the drive shaft in the working position the
minimal overlap of the tubes must be at least 1 / 3 the length of the tubes themselves and must remain a
minimum clearance of 5 cm. The angle at which it works the drive shaft should be as short as possible and
Chapter 5
Start
Machine preparation
Tractor attachment
