12
WARNING:
During the attack do not tilt the chassis by undermining the proper conditions for stability and
security.
NOTE:
Each time you operate, insert the machine screws pins or safety pins and make sure that it can no longer
slip out of their seats. Not reversed and never change the mounting points.
Before engaging the PTO, make sure that the speed of rotation is the one provided by the machine and it is also
marked with a special sticker placed near the gear
.
In the operational phase (with pdf inserted and the rotor of the forestry shredder in movement) make sure there
are no people involved at a distance of less than 50 m. from the machine.
For all handling operations, the operator must remain seated on the seat of the tractor and at a distance from the
levers of command does not exceed the length of his arm.
Do not stay and do not go into the space which remains between the shredder and the tractor under any
circumstances and for any reason.
With the machine connected to the tractor Never approach your hands or feet to the machine itself, in no case
for any
reason.
The only exception is a possible failure or block. For this event see "Possible problems and their solution" before
you act!
The operator must control the forestry shredder with pure control levers located in the tractor cab. Initially the
movements of the shredder can be verified even without inserting the pdf ..
-
Run the cardan then try to move the control levers.
-
The company NOBILI S.p.A. recommend that you familiarise yourself with the movements of the machine
acting with prudence and levers gradually. This is to avoid abrupt and unpleasant surprises.
TIP:
before you start the process of grinding forward with the tractor must start the rotation of the rotor. Raised
slightly the forestry shredder from the ground and enter the PTO of the tractor slowly, taking down the speed of
the engine. Then lower the forestry shredder and then increase the speed until the speed set for your machine
(see technical data table).
Then, try to lower the lift of the tractor until the rotor going to start working on the ground. The machine must now
support a uniform field throughout its surface.
WARNING!
Any movement of the machine must have a very slow start. Run then the control levers with caution.
WARNING!
It 'absolutely forbidden to leave the tractor unattended in motion when the machine is attached. Also
remember to unplug the PTO just finished work.
NOTE:
You should avoid excessive stress on the protective hood plumbing which does not originate from its
own weight. This is to ensure the necessary working conditions and its duration.
Start and movements validation
